LBSCR A1x Terrier Loco Stepney Hueforge

After seeing the wonderful hueforge prints available on here I decided to try a few for one of my other hobbies, UK Railways

This is a plate of a London Brighton and South Coast Railway number 55 “Stepney” which is preserved at the Bluebell Railway in Sussex, UK

If you have any particular loco you would like to see done then please leave a message on here and I will see what I can do

Printed on my X1C carbon with AMS and 0.4 nozzle but AMS not required, you can just manually do the filament changes as required

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size

You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.3mm

Filaments Used:
   PLA BambuLab Basic Black Transmission Distance: 0.3
   PLA BambuLab Basic Blue Gray Transmission Distance: 3
   PLA BambuLab Basic Grey Transmission Distance: 1
   PLA BambuLab Basic White Transmission Distance: 5

This print uses 4 unique filaments

Swap Instructions:
   Start with Black
   At layer #8 (0.72mm) swap to Blue Gray
   At layer #13 (1.12mm) swap to Grey
   At layer #20 (1.68mm) swap to White for the rest.