Search models, users, collections, and posts
Terraonion MODE Hard Drive Retention Bracket V2
Remixed by
IP Report
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
19 min
1 plate
Open in Bambu Studio
Boost
0
1
0
0
2
3
Released
Description
When I printed the original model, it would not securely hold a hard drive. The model was updated to securely snap on to the MODE mount. This means some force from the bottom of the clip is required to remove and it might have limited number of on/off cycles.
You can find the base mounts at:
- Dreamcast: https://makerworld.com/en/models/17183-terraonion-mode-sega-dreamcast-mount-ssd-hdd-mount
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)