Search models, users, collections, and posts
Haircatcher for shower
IP Report
Print Profile(1)
0.2mm layer, 6 walls, 100% infill
Designer
1.4 h
2 plates
Open in Bambu Studio
Boost
34
98
3
0
59
47
Released
Description
Hairtrap for long showerdrains
it is designed to catch the hair before entering the drain. just lay it infront of the drain.
it is 25cm wide so it fits perfectly on the buildplate and makes it possible to print several in one go.
i also designed a little clip that fits into the holes in the ends to connect several together.
it doesnt require additional parts.
the “knobs” are prone to stringing with the tpu, so just hit them with a lighter or heat afterwards to remove the strings
i printed it outoff 95a TPU from polylite and the clip is made outoff petg
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (3)