Bambu Lab X1, P1, P2 Large Pill-Shaped Door Handle

this handle fits:

X1

X1C

X1E

P1P (with door)

P1S

P2S

and future models using the same 256mm build volume and glass door 

This is a remix of ELLANAS' awesome Bambu Lab Wide Door Handle, modified to have a pill shape, with or without the Bambu Lab logo icon. The print profile is set up for PLA, and I recommend you print the door ‘feet’ in TPU, but they can also be printed in PLA, PETG, etc. 

Uses the same screws as the original door handle, just un-screw, and screw on this replacement. Designed to fit flush and tight, so long as you keep the rubber grommets holding the screws, you should be able to tighten the main post down so it doesn't wiggle. 

• The Bambu Lab logo version has Archimedean spiral set up for the bottom layer pattern to be used with Silk silver (as in photos) for a machined look, to go with a plain look, just reset the bottom pattern to default or other pattern. 
• The no logo version has Concentric set up for the bottom layer pattern to be used with Silk silver (as in photos) for a machined look, to go with a plain look, just reset the bottom pattern to default or other pattern. 

USE CAUTION WHEN TIGHTENING SCREWS, THE DOOR IS MADE OF GLASS.