The Hongmoon Path Series - The Royal Hero Sword - Blade & Soul - BNS (Great hero, you are truly the hope of our water frog clan, croak)

The second installment of the Hongmoon Path series

Dovetail structure, very firm after direct assembly, you can add glue for extra firmness

Revised twice, this overhanging part is a bit tricky, the original model is provided in the file, the one I printed is 1600% larger, with a total length of 89cm.

Strongly recommend slow printing.

I used Eryone PETG, haven't tried PLA, it should yield much better results.

Below are some flaws in my overhanging parts, any experts, please advise

This is how it turned out, then I tried polishing and using acrylic glue, the effect is much better (at least I can't see the flaws when I put it on the wall = =)

Bambu doesn't allow publishing conflicting configurations, you can refer to embedding the supports into small cubes, which will greatly reduce the probability of failure, as shown in the figure:

Precautions

It is strongly recommended to use polyurea plates for printing to prevent failures. If not, glue can also be used. I used the official PEI with the official glue, very stable.

The second plate is the original model, you can scale and assemble it yourself.

This model is for learning, sharing, ornaments, and props. Do not use it for rough play, pay attention to safety.

Let's save the Hongmoon together