Mounts for Dyson hair dryer attachments

These mounts allow the individual attachments of the Dyson Supersonic to be attached to a wall, even overhead.

There are two versions

• High: for all attachments
• Flat: for all attachments except "comb attachment"
   

There are two ways to attach:

1. With a countersunk screw in the center of the holder. (Then the screw can be covered with the screw cap.)
2. By gluing with double-sided adhesive tape or mirror adhesive.

Standard 6x10 cylinder magnets (6mm diameter, 10mm length) are used.
Thinner magnets should also work.

To hold the magnets in place, a plug is pushed into the channel behind them.
If the magnets are shorter or longer, the length of the plug can be adjusted in the slicer.

Up to 6 magnets can be installed, but three (every second hole) are usually sufficient.
The poles of the magnets must all point in the same direction.
With the comb attachment, the direction is also relevant.
It is best to hold a magnet to the comb attachment and then
insert all magnets in this direction.

Here are a few links to the magnets:
Amazon: https://amzn.eu/d/7DC99A3
AliExpress: https://de.aliexpress.com/item/1005003128667408.htm

The D6x4 magnets offered by Makerworld also work (but then lengthen the plug by 6mm and, for overhead mounting, possibly use all 6 channels).