Egghead Boot One Piece

This is a 3d Model for EggHead Boot from One Piece. It has a rectangle peg system to help guide pieces together. few options to assemble it

Option 1 - glue everything together - maybe hard to put on boot and take off. Can be hard to walk in

Option 2 - Put pegs in the front and back bottom pieces and glue together. Do not put pegs in top part of back bottom boot piece.  Glue pegs to front top and front middle pieces. Assemble front top and middle top together.  glue to front bottom part. Take top back and middle back and glue them together with pegs only connecting them pieces together. Do not glue them to the rest of the boot. Instead you can slide the back piece on and off the front pegs allowing a person to get boot on and off by taking off back piece when ever. You could add magnets to the top part of back bottom piece to help secure it.

Option 3 - glue everything but the top back piece. Do not put any pegs in top back piece. Also do not put any pegs on top part of middle back piece. This will allow the same concept of option two but may make the boot sturdy. You can remove top back piece as needed to give better access to get foot in. 

Measurements will fit 10.5 inch foot

16 inch top opening

22inch height

3 inches of that from bottom of boot

If you wish to scale model to fit you foot size recommend you print several layer of the front and back middle piece first. Use this a test piece to see if you need to scale boot up or down more. Make sure if you scale one pieces one way you do all the pieces that way. With it being a rectangle peg system should allow everything to be scaled.

(Please Make sure to mirror model to print second boot.)