Search models, users, collections, and posts
Barrel Shroud for Aero Solus Competition Chassis
IP Report
Print Profile(3)
0.2mm layer, 4 walls, 100% infill
Designer
3.1 h
1 plate
Barrel Shroud without Tracks
Designer
3 h
1 plate
1/4 Inch spacers for shroud
Designer
49 min
1 plate
Open in Bambu Studio
Boost
11
21
7
1
53
25
Released
Description
Printed barrel shroud for an Aero Solus Compeition Chassis. It will fit over the factory barrel. Once printed I used #6 screws from the hardware store to attach it to the chassis. I printed it in PLA and PA6-CF. When printed in PA6 I did have to run a small drillbit through the holes just to make sure they were clean and the screws would drop into the shroud with no interference.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (7)