Search models, users, collections, and posts
Sanwa JLF Desk Stand - 67.5°
IP Report
Print Profile(1)
0.08mm layer, 4 walls, 10 top and bottom, 15% infill hex
Designer
46 min
1 plate
Open in Bambu Studio
Boost
6
5
1
0
7
4
Released
Description
This is a small desk stand for the Sawna JLF arcade stick.
The JLF will sit at 67.5° in this stand.
The lip for the plate is 2mm wide.
I have tested this print on my Bambu X1C with the following changes to a stock configuration:
- 0.08mm layer height
- 0.4mm nozzel
- 4 Wall loops
- 10 Top and bottom shell layers
- Honeycomb sparse infill pattern
- Hex infill
This was printed in matte black PLA from Bambu.
This print can easily be fabricated by JLCPCB's 3D printing service and should fall into their cheapest shipping bracket bringing the total print cost in black resin to under $5 USD shipped.
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (1)