Search models, users, collections, and posts
Garmin Vivomove Charging Stand
Remixed by
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
32 min
1 plate
Open in Bambu Studio
Boost
20
46
10
1
88
69
Released
Bill of Materials
Bambu Filaments
Select all
Description
DangeMask created a remix for the vivoactive 4S. I added an updated watch holder with the measurements of the bigger vivomove watch.
No support is needed. Just make sure it's oriented with the back side down, “like a pyramid" during printing. :)
I printed with 0,2mm layer height. Around 15g of filament, but you could probably reduce the infill density.
The holder stands secure, sometimes I need to bend the charging cable a little bit so it won't push the light stand.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (10)