Honey spoon
Print Profile(2)
Description
Easy to print honey spoon. No support needed. If you wish, you can also print without infill. I printed the prototypes from pla filament, but I recommend using a more heat-resistant filament. Don't leave the spoon in the hot drink though :D
A word about design. I could have done the slanted thread upside down and printed the piece upside down as well, but I think the upward slanted thread works better because when using a spoon, the honey flows into the cup better. Even when stored on the table, the remaining honey does not drip and make a mess. However, there is a small dilemma here. The spoon should be clean when stored upright :)
I hope you like this design and I hope you comment how this works for you. Thank you!
Boost Me (for free)
Membership
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (75)