Balloon Car
Print Profile(4)
Description
Boost Me (for free)
Like this model? Boost it! Boosts help the designer create new models.
Membership
Join the commercial membership to sell physical prints of this model
Overview
This is a print-in-place balloon powered car that prints in about 60 minutes with multicolor and 40 minutes in single color. Run on smooth surfaces.
- No assembly required
- Use with a 5 inch balloon (small kind)
Also check out the standard version > LINK
Tips for Successful Race!
- Print at normal speeds
- Ensure filament is dry to maintain good wheel spin and tolerances
- Balloon must stay upright
- Do not overinflate balloon – 50 to 75% inflation is ideal to keep balloon upright and avoid dragging
- Install balloon and then inflate by blowing through nozzle
- Seal nozzle with finger until ready to race!
- Run on a flat & smooth surface
Profiles
- R01 - Initial release
- R02 - Added 1mm ground clearance
- R02A - Single color variant of R02
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (638)