Search models, users, collections, and posts
ANT PCB Maker Stepper Motor Bottom Clamps
IP Report
Print Profile(0)
Add the first print profile to earn points
Boost
0
1
0
0
0
0
Released
Description
This is a simple set of clamps for the ANT Compact PCB Maker.
They secure the bottom of the NEMA 11 stepper motors against the MakerBeam frame. Without something to do this, any tension put into the belts will tend to deflect the motors away from the frame.
Installation
- Insert a MakerBeam square headed bolt into the frame.
- Place the screw hole of the printed part over the bolt and the semi-circular tab into the hole on the bottom of the stepper motor.
- Place a washer over the bolt
- Tighten the printed part against the frame with a nylock nut.
Print instructions
Recommended to print in the orientation provided for strength and durability. Will benefit from supports due to the print orientation.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)