No clog high volume poop pipe

I found that the newest version of the poop chute,24V03, was still clogging due to being too narrow and also had a dip and angle at the outlet of the pipe where the hood attached.  I made the pipe wider and worked to make the angle smooth and not have anywhere for the filament to catch.I also extended the outlet to be 1 piece on the bottom instead of 2 pieces and made it so the hood on the outlet only attaches at the top to prevent filament catching.  the full bucket is all purged filament from prints since installing this new version and not a single clog! please note: the hood piece (piece inside that sits over the poop bucket) is snug fitting so it stays in place, if it prints too tight and will not slide into place, please shave a bit off the arms until it fits.  I have also included the new back left panel and top brace from the designer, as their 24V03 pipe that this remix is made from has a differant bottom fitment shape than the original poop pipe.  If you printed your dresser before the designer released the new poop pipe (24V03) please also print the updated rear left panel and brace on plates 2&3.