Sailor Moon Mirror Compact.

This is my version of the Crystal Star brooch worn by Sailor Moon (finally finished phew).

Please read:

The profile I did is the way I have envision it, so there is some Silk PLA on it.

Don't forget to change the materials if your using something else.

There is a tiny area of the top lid that has supports, usually I try not to use these, but I couldn't find any way around it. They can be a little tricky to remove cause its such a tight area, but with some patience you can remove them, and it wont hurt the print cause that part will be covered by the top.

You will need a mirror with no more than 61mm  and no less that 56 mm, with around 1mm of thickness. It shouldn't be so hard to find. I got mine at a dollar store from an existent box.

Glue the mirror and the star top carefully and to try not make a mess, I tried many solutions but I couldn't find any better, it should not be so hard theres enough space to glue it.

Remove any leftover brim from the smaller jewels, these are not too tight but if the brim is not removed properly its not going to fit. I would also recommend using some glue when your placing them on the print.

Connect the the lid to the bottom using the hinge conector (tiny pink pillar), I made it tight to the the outter part of the bottom piece, so you might need some sort of tool to hit it down but its not that hard.

That's it. Hope you like it.

Don't forget to comment and rate. Thank you.