Gridfinity bottle 1x1 bin 100ml Reuse bottle cap

Gridfinity bottle 1x1 square with an internal volume of 100ml capacity.  Integrates a pouring neck that reuses a soda bottle cap (not included in this model).  

Need a cap? Check my 28mm cap models -> https://makerworld.com/@sylva/collections/4546564.

Dimensions :  Gridfinity bin size 1 x 1 (non stackable). 

(mm) : 41.5 x 41.5 x 95. The bottle height is 95mm + the cap so aprox 98mm total. 

Do not rescale them : Gridfinity bins shall always be -0.5mm smaller then the 42mm. 

Reuse your soda pop bottle cap : The pouring neck has threads for a typical soda bottle cap commonly found on the 2L pop and soda bottles. The exact type of cap is PCO-1881 flat top with a ⌀28mm diameter (Newer version of the PCO-1880).

Need a smaller one ? Check my shorter 50ml container here -> https://makerworld.com/@sylva/collections/4546564.

Printing: No supports required.  Must be printed upright, on the bottom of the bottle with the threads up. The threads overhang (underneath the threads) will not produce a visually perfect print with no supports, but the threads works fine with no support . 

Liquid tight ? My PLA bottle print did not leak water if turned upside down for hours, but this is very depended of your print results and might not necessary means its air tight.

Other notes : Would not recommend for food usage. My Gridfinity bins include the magnet compatible inserts, but they do not have the underneath screw holes (not commonly used). The Gridfinity bins shall always be -0.5mm of the 42mm to ease the slide in between bins. If you download model of bins that are 42mm wide, they here not designed as per the Gridfinity standard.