Search models, users, collections, and posts
Print Profile(1)
0.12mm layer, 2 walls, 10% infill
1.4 h
2 plates
Open in Bambu Studio
Boost
72
185
5
5
275
104
Released
Description
Anchors, i split this model and re build the chains to support single extruder operations (thank you AquaForg3D for the original model). the USN slots right into the chain and allows for small attachment points on the chain. chain fowling is as accurate as i could do while still allowing it to print easily. if you want an SCPO or MCPO anchor just print the star a few times and glue it.
Picture is at 118% (3inch wide) (made for a buddy's retirement cake)
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (5)