Search models, users, collections, and posts
ESP32 CAM snap-on frame
IP Report
Print Profile(4)
rounded corners, 0.08mm layer, 2 walls, 15% infill
Designer
15 min
1 plate
sharp corners, 0.08mm layer, 2 walls, 15% infill
Designer
14 min
1 plate
all edges round, 0.08mm layer, 2 walls, 15% infill
Designer
14 min
1 plate
all of them, 0.08mm layer, 2 walls, 15% infill
Designer
26 min
1 plate
Open in Bambu Studio
Boost
9
38
0
0
40
16
Released
Description
Tired of all the bulky, ugly cases for the ESP-32 CAM module?
Well at least I am, so I designed this little snap-on frame for it.
I am still new to Fusion360 and I only tested it on the X1 Carbon, an .4mm nozzle and PETG, if you have any improvement ideas or issues with the model let me know! :p
Print in PETG due to the case needing to FLEX in order to be applied, PLA works too, but may break on removal.
Supports in PETG and similar are hard to remove, so be cautious.
Frame for the upper board will be released soon.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)