Search models, users, collections, and posts
Elegoo Centauri Carbon 3K Spool Holder
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 4 walls, 20% infill
3 h
1 plate
Open in Bambu Studio
Boost
65
93
4
4
429
40
Released
Description
Same as the original model but I extended the middle out to allow for 3KG rolls of filament
no supports needed
Print in PETG or ASA etc
The PTFE tubes are not 100% needed but a nice addition. I superglued mine in place after trimming.
20% infill 3-4walls .2 layer height
it has a built in support so make sure to remove that from the top attachment point before installing
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (4)