Sunlu S1 fan mod 60mm nactua

I adapted @feejai's 60mm fan mount for the Sunlu S1 fan mod. I am running the fan header out the front since i normally leave the lid popped anyway.  

This mod has been working great so far, I am getting much faster and more even drying. Make sure you print this in a filament that has high heat resistance. An early prototype melted a little when I was using PETG. For the the picture attached I used a few washers since I had to replace the original screws with longer ones. This helped give some space, i will probably swap the metal washers out with a high temp washer the next time I'm at the hardware store.  It may be better to print this in ASA or ABS, though. I will update this if I have any issues.