Search models, users, collections, and posts
5-Way MOSFET Holder
IP Report
Print Profile(1)
0.2mm layer, 4 walls, 5% infill
20 min
1 plate
Open in Bambu Studio
Boost
4
7
1
0
17
12
Released
Description
I made this simple holder for a RGB WW LED Lamp project since the backside of the MOSFETs is conductive and connected to the drain terminal, hence they will short if mounted on an conductive metal like aluminium (guess how I know).
As for material I did use PETG, however ABS or ASA would be good options too. In this scenario the MOSFETs don't get warm but keep in mind that they will on stronger currents, so PLA is not suited!
For most 3D printers I would recommend the “tol”-variant with 0.4mm tolerances.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)