Massive Rope Box
Print Profile(1)
Bill of Materials
Description
This massive model will (almost) max out your build volume!!! You will have a 1mm buffer on all sides in X and Y. Unless you have changed certain settings, you actual Z height maxes out at 250mm - this model comes within 2mm of that max height! The rounded corners allow this enormous model to avoid the Exclusion Zone on P1/X1 printers.
If you like this rope design, check out the rest of my rope models here.
Print Settings
I reduced infill for most of the print, but kept a higher amount in the base to get a better finish.
FAQ
Q: Should I remove the purge line(s) before printing starts?
A: I recommend leaving it, but that's up to you. If you choose not to remove it, the purge line can easily be removed after the print is complete. If you want to remove it, be quick! The print starts in the front, so you have very little time!!!
The following filaments were used in the pictures above:
- Bambu Lab Basic Bright Green PLA
Membership
Are you looking for a Commercial License for all JamesThePrinter models?
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (12)