Print Profile(1)
Description
Due to a reorganization of my desk, I unfortunately lost the ability to attach the lamp to a shelf as before. Unfortunately, the desk is also so thick that I cannot attach the lamp there either.
Problem identified and solved: If I could simply place it down, everything would be fine.
So, I did just that; two test prints for optimization, and I now have a simple and economical solution to place the commonly available lamp easily and yet stably on the desk.
Since it only serves as additional light in the evening and sits behind the screen anyway, the aesthetics are secondary, and I don't have to buy a new lamp ;)
I cannot guarantee that the holder fits all lamps of this type, but I strongly assume that the geometry is quite uniform.
It is dimensioned so that it can be easily slid on with minimal resistance.
I printed it from PLA Basic with the default settings.
Constructive feedback is welcome, and if problems occur during printing, I will try to find a solution as quickly as possible.
Suggestions for improvement or comments are, of course, also welcome <3
I hope someone can use this and that my solution helps others :D
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)