I like it, good fit of the different components.
I put some negative cylinders in the slicer to make space for the filament tips as you can see in the picture.I don't think the creation level is high enough to create a remix for this.
Thank you for your comment. I did not reserve space for the filament when designing because if I did not cut it off, it would be more troublesome to replace the printing nozzle. Therefore, I did not take into account the space for the filament. Your handling method is also a good one, thank you for sharing!
Looks very good, used my own pin for the joints.
Maybe it would be a good idea to change the Inner life of the box a little, cause there is always a little bit of filament sticking out of the topside after prints are finished.
So the nozzle isnt fitting perfect in the box, if you dont cut the rest of filament on the top.