Grindelwald Johnny Deep
Print Profile(1)
Description
Description
Do NOT adjust the Z height (thickness) in your slicer!! The layers will not print correctly. You CAN adjust the other dimensions (X,Y) however to make it larger or smaller, but not the thickness.
Print at 100% infill with a 0.08mm layer height using a 0.16mm base layer
I have also included a pause so you can change filaments if you only have a single AMS
Filaments used:
Bambu Lab PLA Black Transmission Distance: 0.3
Bambu Lab PLA Basic Blue Transmission Distance: 4
Esun PLA+ Pine Green Transmission Distance: 1.2
Bambu Lab PLA Basic Red Transmission Distance: 3.9
Bambu Lab PLA Basic Yellow Transmission Distance: 6
Esun PLA+ Bone White Transmission Distance: 5
Bambu Lab PLA White Transmission Distance: 5
This print utilizes six distinct filaments
Instructions for swapping:
Start with Black
At layer #3 (0.32mm) swap to Blue
At layer #5 (0.48mm) swap to Black
At layer #7 (0.64mm) swap to Pine Green
At layer #8 (0.72mm) swap to Blue
At layer #9 (0.8mm) swap to Red
At layer #11 (0.96mm) swap to Yellow
At layer #12 (1.04mm) swap to Bone White
At layer #18 (1.52mm) swap to White
At layer #21 (1.76mm) swap to Yellow for the remainder.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (1)