Radiomaster Pocket Fixed & Spinning Stickends
Print Profile(1)
Bill of Materials
Description
Boost Me (for free)
Designing and creating these models takes lots of time and effort! Please consider supporting me by boosting this model. It's free for you and help me a lot!
Updates:
- Added a new very short version of the Spike Dome design for lower profile thumb pilots
- Added a revision to the fixed mount spike ball design as well as 2 new designs.
Through Mounted
Used for the Radiomaster Pocket, or any radio that has a female M3 mount on the gimbal. Print on the finest detail that you can. They can be printed with a 0.4mm nozzle but 0.2mm is better.
Installation:
- Install by screwing the M3 20mm through the grip
- Then put the spacer on the bottom
- Put on the cap (if the stick end uses a cap)
- Attach to gimbals
Spinning Stickends
Print on the finest detail that you can. These are a bit of an experiment with non-fix stick ends.
Installation:
- Place the spinner top on the M3 20mm screw
- Attach the Spinner Spacer. The spacer should be snug to the shaft but the top should spin freely. You can adjust the tension on the top by turning the spacer more.
- Place the Cap over the hole on the top once you've dialed in the friction on the spinning top
- Attach to gimbals
Other Designs
Have another radio? Check out my collection of other FPV upgrades and improvements
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (24)