GBFlash Enclosure - Free 3D Print Model

Search models, users, collections, and posts

ShikyC

Hobby & DIY>Electronics

IP Report

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

A1 mini

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.2mm layer, 2 walls, 15% infill

Designer

55 min

1 plate

5.0(1)

Open in Bambu Studio

Boost

Released

Description

Just a simple case/enclosure for the GBFlash board (USB-C) version. 4 screws needed (just use those from the original GBFlash board).

Better printed with translucent materials like PETG.

Didn't implement the button on the board, so to upgrade the firmware, you need to disassemble it, or add this button by yourself (FreeCAD source file attached).

gbflash

gba

gbc

Comment & Rating (3)

@astorrer

Print Profile

0.2mm layer, 2 walls, 15% infill

Really good dimensions, cable plugs in smoothly. Things that could really take it to the next level are countersinking the screws about 1.5mm so they are flush, and slightly re-enforcing the top half of the case above the cartridge slot. As for a button, the material is flexible enough, a 3/4 side cutout with a plastic wedge below it could serve as a button. But these are nitpicks, really good work.