Studded 3 Ring Gyro Fidget Spinner

Introduction

A 3 ring gyro fidget spinner with a diamond studded texture on the outer edge. The outer edge is flat in one direction, allowing the gyro to stand on the edge and roll. It has pivot points on the rings giving fixed directions of spin. 

If you're interested in a giant version of this, take a look at my Giant Studded 3 Ring Gyro Fidget Spinner.

A range of gyros featuring the same core design but with different outer textures can be found in my Gyros Collection

Specification

• Diameter 44.5mm
• Height 14mm
• Weight ~16g

Printing

Select from the various profiles as follows

• Top Bottom Colour - The top and bottom 1.3mm are a different colour to the main body
• Single - All one colour
• Dual - Evenly split into two colours
• Triple - Evenly split into three colours

If the gyro does not spin freely when removed from the build plate a few spins should break it in. If this fails try manipulating the rings against each other. I found squeezing the ring inwards at the pivot points and rotating the next ring followed by squeezing the ring away from the pivot points and again rotating the next ring to be particularly effective. if this fails then reducing the flow ratio slightly and checking pressure advance settings should help.

Featured Filaments

• Bambu  PLA Galaxy - Nebulae
• Bambu PLA Galaxy - Purple
• Sunlu PLA Silk - Red Copper
• Overture PLA Silk - Green
• Overture PLA Silk - Blue
• eSun PLA+ - Red
• Sunlu PLA+ - Green
• Sunlu PLA+ - Yellow