Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, 6 walls, 15% infill
Designer
1.1 h
1 plate
Open in Bambu Studio
Boost
1
2
0
0
0
0
Released
Description
Content has been automatically translated.
Dual-Head Magnetic Pen
Instructions: Use two 6*5mm magnets. When the overhang begins printing (the path turns blue), add a pause layer, then insert the magnets, one on each side. After printing, use the center column to connect the two halves; a small amount of glue may be helpful.
Usage: When installing magnets, apply a small amount of glue to the hole, press a magnet into place, then gently slide it to the side for elegant installation. It's also excellent for retrieving screws from small boxes.
The contact area between the pen and the printer is small, so be sure to add a brim. Print PETG slowly; PLA usually has no problem.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)