Progresso Can Rack - Free 3D Print Model

Search models, users, collections, and posts

Remixed by

heedaf

Household>Other House Models

IP Report

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.24mm layer, 4 walls, 30% infill

Designer

33.9 h

8 plates

5.0(1)

Open in Bambu Studio

Boost

Released

Description

This is based on the Vegetable Can Dispenser by cbaileyhp which is larger and accommodates Progresso's wider soup cans. It should work ok but I don't have any Progresso soup cans to test it with. I modified it based on a couple of user requests. Please let me know if there are any issues.

can rack

Comment & Rating (7)

@user_3440802946

I printed this for use with Progresso soup cans and I'm not going to be able to use the model without modifying the result. Upon testing, cans catch in the center of the rack track because it runs into the posts that hold it together in the middle. This is so close to having enough room that you can push the can to force it to continue, but it is not going roll freely. The center posts need to have a smaller radius or need to be flattened on the bottom so that the cans have just a tiny bit more space to clear.

The designer has replied

@heedaf

Try sanding them down so you don't have to reprint it.

@user_3440802946

Replying to @heedaf :

That's the plan for this print because those cans just barely miss on the clearance and the model uses an entire roll of filament. This was so close that it is only hits on the very top and bottom where the can is sealed. You would only need a couple of millimeters to make it work if you make updates.