Search models, users, collections, and posts
Union Pacific RR Overland Rte Coasters
IP Report
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
3.9 h
1 plate
Open in Bambu Studio
Boost
14
29
1
0
14
9
Released
Description
Union Pacific Railroad “The Overland Route” Coasters
These coasters are 89mm square and 3mm thick.
This print profile worked just fine on my X1C
I always apply a self-adhesive cork backing to my coasters. I have listed a link to them on Amazon. You will most likely have to trim them slightly. https://a.co/d/0PjaF1i
Take a look at my other railroad and non-railroad coasters and clocks at https://makerworld.com/en/@railimages
Boost Me (for free)
Boost Me (for free)
I would appreciate it if you could rate my model and profile and if you really like it and have an extra BOOST, maybe you could leave it here
It would be greatly appreciated!
Thank you and enjoy!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)