Cover Poop container by 3D-Print-Bunker

3D-Print-Bunker

3D Printer>3D Printer Parts

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 15% infill

Designer

18 min

1 plate

4.3(11)

Boost

120

Released

Description

Englisch:

I got a silicone scraper from Sven Krause (Facebook, “Bambu Lab Community” group), including a holder. This works very well and cleans the nozzle much better than the original scraper. Now I have constructed a suitable cover for the poop container. Together it works great and there are almost no more “poops” on the heated bed.

Deutsch:

Ich habe von Sven Krause (Facebook, Gruppe "Bambu Lab- Community") einen Silikonabstreifer bekommen, samt Halter. Dieser funktioniert sehr gut und reinigt die Nozzle deutlich besser als der originale Abstreifer. Nun habe ich dafür eine passende Abdeckung für den Poop Container konstruiert. Zusammen funktioniert das super und es gibt so gut wie keine "poops" mehr auf dem Heizbett.

bambu

cover

poop

Comment & Rating (20)

@virpio

Print Profile

0.2mm layer, 2 walls, 15% infill

This caused issues for me. When the printer is draining the nozzle, this caused the poop to get stuck between the chute and this cover, causing it to eventually fail after collecting so much poop that the front of the extruder fell off.

(Edited)

The designer has replied

@Krall3

Wow, you're the first to have this problem.

@danimar.gabriel

man that is a big mess there hope that nothing break

@virpio

Replying to @danimar.gabriel :

no, all good. I guess I was lucky that the front fell off before it got worse.

@cdx1967

Print Profile

0.2mm layer, 2 walls, 15% infill

This is the second model of this type I have printed. This being the better of the two. It fit in the printer as designed and I believe that the model itself is of good quality. However, both models I tried caused issues during actual operation of the printer. At some point during a print purging filament came into contact with the model which them became unseated. During further purging the print head then struck the model repeatedly and caused a rather large backup of purged material.

The designer has replied

@Krall3

@cdx1967: Hello, I haven't heard of this problem yet. It's been running for me for many hours without any problems. Do you also have the silicone wiper? I rarely have a small piece of filament end up on the print bed, but I haven't had any kind of filament backlog yet.