Search models, users, collections, and posts
Stormlight Archive Radiant Banner Pole DIY Kit
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 10% infill
Designer
22.5 h
2 plates
Open in Bambu Studio
Boost
26
92
0
4
28
10
Released
Bill of Materials
List other parts
- 1" x 5' diameter pole/dowel rod x 1:
- 1" x 3' diameter pole/dowel rod x 1:
- #4 3/8 in wood screw x 1:
- ¼" x 1-¼" Dowel Pin x 1:
Description
Banner Pole DIY kit for the banners included in the Stormlight Archive Words of Radiance Kickstarter (and potentially from the Dragonsteel store in the future).
This kit requires extra materials in addition to the 3D prints
-2x 1" diameter poles/dowel rods (I used a 5ft and a 3ft in my kit, these sizes can be found at Home Depot for $7-$8 each and require no cutting/sawing)
-1x #4 3/8 in wood screw
-1x ¼" x 1-¼" Dowel Pin
The stand should be printed around 25% infill to hold the weight of the banner. Other pieces printing around 10% infill.
Assembly of the middle bar requires glueing the dowel in between the 3d printed bar parts, then using the screw to hold the bar in place on your pole.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)