RG Nu Gundam Funnel Adaptor to fit WFM stand

I designed these adaptors to allow me to use the Bandai Witch From Mercury Weapons stand with the RG Nu Gundam Funnels. 

I have three different adaptors. Please note that they will be tight to get on initially to the stand pieces so just rotate them gently until they go on and off and move around easily. The connector into the rear of the funnel is also a tight tolerance but it does go in and wont sag. The photo shows my WIP Nu Gundam funnels attached to the stand. 

1 - Rear Mount - This is just a straight hole in the back

2 - Side Mount Vertical - This has a side mounted hole and allows the funnel to be displayed in the vertical postion

3 - Side Mount Horizontal - This has a side mounted hole and allows the funnel to be displayed in the Horizontal postion

4 - This plate has 4 of each to print at once

I printed this using eSun PLA+ with no supports and at 0.16mm. 

Note if you are downloading the STL files you will need to flip the rear mount 180 degrees to print.