Search models, users, collections, and posts
Suzuki Carry DD51T Vent Fin Connector/Control Arm
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 100% infill
Designer
18 min
2 plates
Open in Bambu Studio
Boost
10
20
2
0
22
6
Released
Description
The vent on my 1998 Suzuki Carry (DD51T) broke. Instead of the fins moving together, they all moved independently and would not stay in place. The connector/control arm needed to be replaced and I figured I'd give it a shot to make my own. I made 2 slightly different pieces. One is meant to be printed in TPU If you print this on in anything else you will be VERY FRUSTRATED. The other piece is made to be printed out of harder plastic like PETG. Both work well, but the PETG version doesn't hold the vent in position quite as well as the TPU version.
IMPORTANT:
The TPU version has circular holes.
The PETG version has oval holes.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)