piercetroll

cover

Big Lantern.jpg

Lantern.jpg

plate_1.png

plate_2.png

plate_3.png

plate_4.png

2025-02-19_644b131dd05758.jpg

I have wanted one of these since I was a kid, and the “official version” was out of my reach, so ….&nbsp;The model uses an assortment of settings, but please use your discretion when applying them!&nbsp;I have used a couple of modifiers to get some desired finishes. The top has a Hilbert Curve modifier for the top surface, and the lenses have a reduced wall count, and infill set to lightning. &nbsp;I have it set as a 100% model, but have printed it at 200%. At 200%, it is life size!  I have dropped holes for pegs, or magnets, but found it unnecessary as if fits together very well. If you are planning to use this as a cosplay item, I would glue them up, but as a display piece, it works just great snapped together!&nbsp;The lenses when printed, snap into the flares, and then the lenses snap into the body. It took a little post processing to get them perfect, but it was minimal. ( light sanding around the edges where the supports were, and a quick shot with the pipe reamer if it is being stubborn.&nbsp;You might consider to use support interface if you print this in silk, on the top dues to the massive amount of supports inside. I had a really hard time getting the support mesh layer out of the top, so if you decide to plop a light in it, it will actually light up.&nbsp;You can separate the pieces together or on separate plates if you like, I condensed them onto 4, for ease.&nbsp;3 walls, 5 top, 3 bottom layers, 15% cross hatch, and tree supports, but check the slicer if you are going to make it big, you might want to increase the top layers on the logo piece to get a nice transition of colors, and check the brims on the flares so they don&#39;t run away.. That sucks.. LOL

0.2mm layer, 3 walls, 15% infill

In Brightest DayIn Blackest NightNo Evil Shall Escape My SightBeware My PowerGREEN LANTERNS LIGHT&nbsp;This modular replica of Green Lantern Hal Jordans Power Battery is something I have always wanted.. I used Fusion 360, and did my best to make it as close as I could using photos and other resources from the internet.&nbsp;&nbsp;

Green Lantern Power Battery

ASIA

Print Profile(1)

Description

Comment & Rating (64)

License

Related Models