"Invisible" Tablet Wall Mount
Print Profile(2)
Description
“Invisible” Wall Mount for Tablets
This mount consists of two parts, which fit together with a sliding dovetail.
One gets screwed to the wall with three screws.
The other gets glued to the backside of the tablet.
Tips for gluing
Most glues will (temporarily) soften with heat.
This heat could realistically occur through for example the sun or (fast) charging of the tablet. So make sure you are using the whole contact area for glue to minimize chances of the glue failing.
I used some simple carpet tape and it has been holding great. But for a stronger mount I would probably recommend using 3M VHB double sided tape and waiting the recommended ~24hrs before putting any load on the glue (→ let it sit horizontally). Also it is sometimes recommended to compress the glue directly after applying it (use common sense, the 3d print and your tablet could suffer. Again i am not responsible, if you break your equipment or 3d print).
Printing, Assembly & Tolerance
FYI: Both parts on the same plate are slightly too large for the A1 Mini, just print them seperately :)
The prints get put together with an integrated dovetail after mounting both parts to the respective parts.
The dovetail can be a bit tight on the first insertion, but will get easier after a couple of insertions.
Please note that I only tested the fit with a 0.6mm nozzle.
If the tolerances don't match at all, check your printer adjustments and filament!
(I would recommend scaling the wall mount part by a couple 0,01%)
IF THE GLUE FAILS AND YOUR TABLET FALLS OFF THE MOUNT, YOU ARE ON YOUR OWN.
THIS PRINT IS UPLOADED WITHOUT ANY WARRANTY OR GUARENTEE WHATSOEVER.
Comment & Rating (16)