Search models, users, collections, and posts
Sandbag Fortification - Trench Crusade remix
Remixed by
IP Report
Print Profile(1)
0.08mm layer, 2 walls, 8% infill
Designer
16.3 h
2 plates
Open in Bambu Studio
Boost
56
223
2
1
91
36
Released
Description
A remix of Anumbara´s original version, where I increased the height of the sandbag bunker to accommodate figures from Trench Crusade. I used a Iron Sultanate Janissarie as a height guide. I also lengthened the ladders somewhat to fit this new height.
The print profile I used is at 0.08 mm layer height, 8 % infill, with manual tree support only on some parts for the sandbag bunker. Other than that, it prints without any supports.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)