Search models, users, collections, and posts
Festool CT-VA Cyclone Systainer Hose Holder
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 12 walls, 15% infill
Designer
6.9 h
2 plates
Open in Bambu Studio
Boost
177
778
87
41
749
529
Released
Description
I printed the original model and realized I would like to make a few changes to it so I designed it from scratch in Fusion360. I made it as wide as possible (150mm) while still fitting in the Systainer and then I made a version which is split in two 50mm sections if someone wants to use less filament.
NOTE: will only fit SYS-2 systainers, it is NOT COMPATIBLE WITH SYS-3 and I don't think I'll be able to make a SYS-3 version soon, at least not without adding an MDF MFT-Style top.
NOTE 2: the Systainer's lid cannot be opened with the holder installed, it is meant to be used primarily with the CT-VA Cyclone.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (87)