poop chute for P1/P2/X1 (Chute and Boxes)

Update:

Version 1.1 with a larger inner radius - the poop is discharged better ;-)

Hello printing friends,

here is an essential attachment to make your P1 or X1 printer even cleaner (P2 should also work) 

In the past, I naturally already used a chute. This one was open at the top and could never properly contain the waste from my P1S printer. Therefore, with my version, I seal all escape possibilities for the poop's as well as possible. Furthermore, the design is chosen so that your printer can stand close to the wall. You only need 35 mm of space to the wall

All you need are merely 3 round magnets with dimensions 8x3mm and some glue (a little) to fix them in the recesses. I will spare you installation instructions for this step, everyone should be able to do this ;-) 

The upper screw for fastening must be slightly longer than the original

I printed the chute multi-colored with PLA. After a longer testing phase, however, I would now recommend PETG or ASA. With these filaments, the poop is simply transported better. If you don't like colors, print everything in one color, no problem. The chute just barely fits on the build plate of a P1 or X1 printer - Attention, scaling makes no sense!!!

Print plate 1 contains, in addition to the chute, a 15 cm box. You should print this box if your printer is placed on a table without elevation. If your printer is elevated, for example, on a concrete slab or vibration-damping feet, there are two more boxes. One box is 2 cm and one is 4 cm higher at the "entrance". Simply swap the small box with your preferred one on print plate 1. This way, you only have one print job in the end! :)

What remains now is to wish you much success with printing!

Pictures, gladly in the comments!!!

Here you can get the model for the H2 printers!