Jimy Longs Pick Plugs

For anyone using Jimy Longs lock picks, I designed these little plugs that put in the hole on the end of Jimy Longs lock picks. I use them to  organize my picks by width--in the picture for example, the hooks with the red plugs are .019, while the hooks with the yellow plugs are .015. Makes it easier to tell the difference quickly by looking at them. 

Installing them is simple. I've included some pictures that show how it can be done. No tools  necessary.

1. take the male piece of the plug (the part with the little piece jutting out of it)  and place it flat down on the table  (little piece sticking up)
2. place your Jimy Longs pick handle on top of the male plug piece so that it sticks through the hole at the bottom of your pick.
3. now take the female piece of the plug and drop it through the hole at the bottom of your lock pick onto the top of the male piece so that the two pieces of the plug fit into one another.
4. firmly press the female piece onto the male piece. You can pick it up at this point and squeeze the two sides to get with your fingers to make sure the two pieces are firmly together.
5. That's it, you should be good to go!

Should you want to remove the plugs at any point, they are easy enough to pull apart using either your fingernail, or something else thin that can gently pry at the edge of the plug to pull it apart.

Hopefully that was clear enough directions, it's not rocket science though, so I'm sure you've got this!

The print profile and STL are for a single plug, just duplicate for however many you wish to print. They are small and print rather quickly. Hope you enjoy!