R36S Retro Gaming Console Grip - Pyreling Remix

A remix of drbaph's R36S grip design, which is of  Devongb's RG353V design.

This was my favorite freely available model that I found, but had a few adjustments I made for my own usability.

1 - Opening for USB/Audio ports as well as vents.

2 - Flattened the bottom of the grips so supports are only needed for the flat section under the console. 

3 - SYMETRICAL - The left/right section were a bit different, so I cut the model in half, and mirrored it.

4 - Angled the top back, for less interference/uncomfortability when accessing back buttons.

5 - Flattened/trimmed the front section, for more comfortable access to the buttons.

6 - Slightly scaled down for a tight fit without additional materials. (Printed in Polymaker Draft PLA) . Please let me know if the fit is too tight/loose for you, and I will add notes to this file accordingly.  

NOTE - If you do not like the flattened section on the handles, select the following for the “Smooth Handle” version. 

I have no issue with this model being used commercially, but the remix I started from is listed as “Non-Commercial”. I'll see if I can get permission from drbaph to get this changed.  — Just received permission to set this as commercial. Go nuts!