Razer Leviathan X v2 VESA mount

Please see the NEW upgraded version here: https://makerworld.com/en/models/1311067-razer-leviathan-mount-upgraded-version#profileId-1345374 

The upgraded version is both reinforced and now has compatability with the Leviathan V2 and V2 X.

I made this model per a request from a user on Maker World. This is a 100mm X 100mm VESA adapter to mount a Razer Leviathan X V2 speaker to the bottom of your monitor, holding it up off your desk for a cleaner appearance. I designed it to be adjustable to not only accommodate a wide range of monitors, but to also allow for clearance for the Leviathan buttons as well as monitor power and adjustment buttons. 

Note: I obviously cannot guarantee fitment on all monitors due to design choices by different manufacturers. However, I did do my best to offset the mount where it attaches to the monitor so that I could increase compatibility. Additionally I created another print profile with 2 and 3 mm spacers and an extended arm for monitors greater than 12 inches (31 CM) tall. I also deliberately increased tolerances so that if your printer isn’t tuned the same as mine there will be some play to allow the parts to fit together. I included shims that can be slid into the connected parts to reduce the play and increase stability. I personally have tested this on the following monitors with success:  MSI MPG 491CQP (49” Ultra Wide), ASUS VG247, Alienware AW2518HF, and Alienware 2523HF.

Warning: Do not use the same screws you are currently using to mount your monitor. This mount was designed to be 4mm thick, so you need to measure your current screws and replace them with new screws that are longer. I am not responsible for damage resulting from using incorrect screws.  I found that M4 x 14 worked great for my 24" monitors and M4 x 16 worked for my 49" ultra wide monitor. I recommend 100% infill on the spacers if you need to use them.