Search models, users, collections, and posts
Sugar Powder Sifter
IP Report
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
4.9 h
3 plates
A1 Mini
Designer
4.8 h
4 plates
Open in Bambu Studio
Boost
97
300
23
12
266
166
Released
Description
Here is a simple, mechanical sugar powder sifter.
I've needed one but I wasn't happy with existing designs, so I've made my own from scratch:
- Few parts, easy to assembly (tight joins may need to use some force)
- Fits nicely in hand
- Large capacity
- Easy to open and refill
- Comes with extra cover plate to put on when not used
- Inner rotor design prevents holes getting stuck
- Works best when its fully filled up!
Printing info:
- No supports
- No brim
In case of adhesion problem on small parts - slow down your printer and make sure your bed plate is clean (I do not recommend adding brims as they will leave sharp edges)
!!! FOOD SAFETY - USE AT YOUR OWN RISK !!!
Make sure your filament is food safe!
------------------------------------------------------------------------------------------------------------------------------
See also:
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (23)