Drum cymbal stand headphone holder - 14mm -> 20mm

Headphone stand for your drum kit, attach to your cymbal stand and rest  your headphones on the stand. 

Given that the size of the tubes in use on cymbal stands seems to be different per brand, I've made a holder suitable for 14mm, 15mm, 16mm, 17mm, 18mm, 19mm and 20mm, they are separate plates, so you only need to print the one you need. There is also a small bit of adjustment when fitting, both a tiny bit of stretch and also a small amount of contrition when tightening up the clasp. 

You will need an M4 screw / bold and nut. The size of the nut is 7mm (flat edge to flat edge). 

Choose the correct plate to print, once printed, clear out the supports with a small pair of pliers (do the sides, then the middle from the underneath) and push fit in the nut.

Take the two parts of the cymbal stand apart and slide this up the tube to the desired location, then tighten by threading the 4mm screw / bolt through until it's tight on the cymbal stand. 

You can now hang your headphones!