Disposable Glove Dispenser, Box for Disposable Gloves

I'm seriously wondering why you printed the box twice when you should have noticed the first time that you didn't like it! The fact that you're complaining to me about how much filament and print hours you used for it somehow doesn't make sense to me. You could have easily found out the size of the box BEFORE printing, and you could have seen then that the box was too small for you! You could have seen everything you're complaining about in the preview before you printed it. I also never said that a whole pack of gloves would fit in the box. So why this comment please?

Hello my dear, I printed the boxes in one print and not one after the other, of course. My description is only intended to show others my findings on the model. Nevertheless, the opening for removing the gloves is very disadvantageous, very small, and the lid doesn't hold perfectly either. These are points that I couldn't notice at all. I was quite aware of the size, but nothing directly indicates it, I would still have had use for the small boxes (in original size). However, the "disadvantageous construction" of the lid and the opening in my eyes has led to the boxes not working so well. I haven't left a review (so I haven't given you a negative review for it), I've only expressed my criticism. Maybe this will also help you to "improve" the box. Kind regards NoX3

I certainly don't get upset about constructive criticism, but in your case, I don't see it that way! Apart from the fact that the box has been printed 141 times so far and I have received ratings and comments from two other users besides you, namely, as you yourself may have read, one thought that the glove packaging itself would fit into the box, which was absolutely not in my description, I have received no negative reaction whatsoever. I tried the box myself again. The lid holds perfectly and the gloves can be pulled out without any problems and they don't get caught anywhere! That's why I don't quite understand your comment somehow

Then I wonder why you deducted a star from me just because you printed the box smaller than indicated in the original file!! That's not my fault!

I guess you don’t understand what you read. I said I printed it the way it was in the original size. Never changed a single setting. was a waste of time and filament. ended up designing my own box.

That can hardly be the case, I have commercially available disposable gloves in the box I printed and the slot is large enough to pull the gloves out ! I also didn't write anywhere how many gloves fit in the box !

The gloves are also not meant to go into the box WITH the packaging That should be clearly visible shouldn't it To give me only 3 stars for that because you misunderstood is not fair :-(

Thank you for your 5 stars

Dankeschön!

That's a splendid idea, thank you!