Notebook feet for Dell Precision 7670

I wanted the back of my Dell Precision 7670 slightly, so some legs were needed.  These MIGHT fit other Dell Precision models, but as I don't have any of those there are no warranties whatsoever on this.  Please do not leave bad evaluations just because the part didn't fit your different notebook.

This notebook has the power connector on the back left, which required an opening in the foot allowing the power plug to pass through.

There's also not much room between the body and the display of this notebook, so the top is kept fairly thin.

To keep things robust enough despite this thin top, I strongly advise printing these fit in PETG (or something with even better layer adhesion).  The brittleness of PLA will likely cause the top of the feet to quickly break off.

Normally you should be able to close the display of the notebook with the feet on, but it is pretty close, so first try it with caution and double-check that you aren't forcing something.