Gillette Venus & Mach3 Razor Holder (remix)

Adjusted this model from the original using the slicer to make it compatible with Mach 3 razors from Gilette.
The angle of the original model was a bit too tight which meant that it wouldn't fit anything other than the Venus razors. Mach3 razors would angle too much into the wall.

Is it the best edit? Definitely not. But it works and it looks fine when printed.

I recommend using a lower layer height to help with bridging issues. It should print well without supports. If you want to use supports instead you can take out the ‘Generic-Cube’ parts as well as the ‘Generic-Double Tear Romboid Cylinder’.