Little cutie - crochet little bunny

failed to print twice. same issue both times, Foorst 2/3’s print fine , then there seems to be a 3mm shift to the left for the top 1/3. Not sure what’s the cause. Printed on my new A1 mini , using PETG filament that I’ve had no issues with in the past 😞😞😞

amazing and a quick print for the size

Have to give it a two out of 5 sadly. Had it fail twice, both times from the left ear. Normal speeds, Sunlu PLA+. If I could suggest something to change in a V2.0 it might be to have the merge into the body a little sooner, like the right ear does. And if the arms sat just a bit lower on the legs that might remove the need for supports there at all. Mabey make them larger, they'd match the legs more that way. and, nitpicking now, the stitching on the legs is a little smaller then the rest of the body , if that was increase it would match better. Love the model, otherwise I won't have tryed it twice, and might give it another go at a slower in the future. Shame it cracked that ear off.

❤️

great print

Super cute design, thank you so much for it! I had read the comments saying that there can sometimes be issues with stability at the ears. So, just to be on the safe side, I redesigned the support structure on both ears. I may have overdone it a bit, but the print came out perfectly on the first try from my A1 mini using PLA+ filament. Once the print has cooled down, simply slide a small screwdriver carefully under the support layer at the ears, and the case comes off very easily.

Left ear support failed once. With 3Dlac adhesive spray no problem. Cute!!

Very cute

This is a splendid gift for my grandchildren; should it be pilfered, I shall be constrained to fashion additional ones in diverse hues

très bien merci