Search models, users, collections, and posts
Wheel Chock for Trailer or Car
IP Report
Print Profile(2)
26 inch Tire, 0.28mm layer, 4 walls, 15% infill
Designer
5.4 h
1 plate
5 inch Tire, 0.16mm layer, 4 walls, 15% infill
Designer
2.3 h
1 plate
Open in Bambu Studio
Boost
255
737
21
15
515
229
Released
Description
This is a very strong wheel chock for a trailer or car. It was designed for a standard trailer tire of 26" diameter, however, it will work for a wide range of tire sizes (12-36 inches). The hole in the back of the chock is designed to insert a rope (up to 0.5") to connect two chocks (see pictures).
The wheel chock prints without supports. I recommend printing with PETG or ASA. My print profile includes 0.28mm layer height (for faster printing), 4 walls, 15% adaptive cubic infill (oriented for max strength), and an infill modifier to strengthen the thin area of the chock.
I hope you find this model useful. Happy Printing!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (21)